In the beginning of this article look at how to remove accumulated air from the fuel system of the car. Remove air from the fuel system is required if: you disconnect the fuel line, if you zavozdushilsya fuel fuel pump circuit, if the engine stalled because it ran out of fuel in the tank, as well as in the case, if you change the fuel filter.
Here are step by step guide for performing this procedure. Step one: relax a little fixing deaerator filter and bolt that secures the sleeve pipe supplying fuel to the fuel pump. Then take a small container and we substitute for the clutch and the deaerator.
If your engine is equipped with a fuel pump that has a molded polygonal head, then you must do the following: unscrew the head a hand pump.
Click the button on the pump, keeping an eye on the fuel, derived from the deaerator. When will the air bubbles, stop the procedure. Tighten the deaerator in the fuel filter.
The next step is conducting such a procedure: press a button from time to time a hand pump and watch closely for fuel, which follows from the bolt sleeve on the pipe to the fuel pump. Pressed to stop when the fuel will be air bubbles. Immediately, quickly tighten the bolt sleeve piping.
Fuel flow should stop when the button pump will provide much resistance to your touch. If your engine has a manual fuel pump, having a molded head, you have to manually tighten the head of the fuel pump.
If you unscrew the pipe replaced or the injection system, run the following sequence of actions: slightly loosen the nuts on the injectors, press the gas pedal, turn the starter. You must ensure that fuel flowed out of pipes with weak attachment.
Secure the piping system of fuel injectors in, run the car engine. Carefully check all pipe joints, start the engine.
During engine operation is necessary to remove old and install a new sensor that measures the fuel level. The order of your actions is this: remove the fuel tank, remove the sensor, using two cross-shaped screwdriver. Next, remove the old sensor. Installation of a new sensor should be performed in reverse order.