1. Installation and removal of the front door
First you need to lock the door open, then unscrew all the screws holding the lugs delimiter for opening the door to facing the front desk, and bolts for fixing loops. Now you can safely remove the door.
The installation should be performed in reverse order. Before the final tightening of bolts loops must always be checked and adjusted by increasing the uniformity of the holes in the hinge gaps that exist between the body and the door.
2. Disassembly and assembly of the front door
Initially, to remove the front door trim and handle control exterior mirrors, full lining and, by reversing mounting screws, clear mirror. Then you need to remove the door seal drain the glass, then remove the protective aprons through the holes in the inner panel. Now you can unscrew all the screws and remove the guide grooves lowered the glass. After that you should unscrew the screws holding the glass lowered and loosen all the nuts window openers, window lift himself off and remove the glass from the top let down.
We can now safely remove the lock from the door lock switch rods, inner and outer door handles. After that, just unscrew all the nuts and remove the outer handle safely to your door. Gradually, enjoy a twisting screw to lock the door. After all these procedures should take the inner door handle assembly with the bracket, first unscrew the mounting screws. If you enjoy a special need for twisting the screws attaching and removing the restrictor opening the door.
Door assembly must be performed in reverse order.
3. Adjusting the front door of the castle
Before adjustment necessary to outline the need for all the contours of the A-pillar retainer lock. If the door closes tightly strongly, it is imperative to weaken the fastener screws, remove him out and, of course, tighten all screws. If the door will be closed sufficiently weak to move the latch slightly inward. Thus in any case should not be sticky or protrusion of the door relative to the body. In that case, if the door is closed when it is raised a bit, or slack in the open position, an urgent need to lower the latch.
4. Removing and installing bumpers
To remove the front bumper repair to unscrew the side screws and brackets, of course, through the holes in the bottom of bumper to loosen the two bolts attaching the brackets. Also, can itself be removed and the rear bumper.