Warnings:
Brake pads, doing your job, and also produce materials that lead to their deterioration and breakage. When their work is formed brake dust containing asbestos which may harm health. Carrying out work on their treatment, do not use compressed air and do not breathe dust. Clean the brake mechanism, using only specially designed for this car brand cleaner brakes. In the event of failure of only one slide must change the whole pair.
Production of disassembly:
Remove the bolts securing the caliper to the holder, to eliminate the turning at the same time hold the second key guide fingers. Disassemble the slide from the holder and the cylinder. Then make removal of brake pads from the caliper holder, followed by removal of the pressure spring. After that, remove the guide pin, then the protective cover. Then turn the pressure springs, remove it. Dismantle and remove the dust cap bleeder. Remove the protective cover after the piston. Clean the caliper of dirt and dust. When risen at the same time do not inhale the dust it, use a protective mask. Securing the caliper in a vise, perform extraction of the piston. For this procedure, apply a low-pressure air into the brake cylinder, using the hole where the brake hose is connected. To do this, instead of the brake pads postavte wooden block. After removing the bar, carefully remove the piston. Remove carefully so as not to damage the cylinder wall, omentum, which is in the groove of the cylinder slide using the edge of a screwdriver-type lever. Check the condition of all the details slide. Make the replacement of worn or damaged. Carefully inspect the cylinder and piston. If you find ticks, scratches, pitting or deterioration, change the piston and cylinder with new ones. Regardless of their status, change all the rubber parts. Make the Flush all parts of methyl alcohol (net brake. Fluid) dry rub them. Compressed air blow holes and tubes.
Assemble:
Put on seal and piston a thin layer of brake. fluid. Perform an oil seal piston. Using a special device or a hammer handle to push the piston cylinder calipers. Tighten the bleeder valve in place and tightened his point 6N • m. Put the guide pin with a protective cover. Install the spring. Put the brake pads. Tighten the bolts, slide holder, we connect with the cylinder. Tightening torque of bolts 26n • m. Follow the blowing air cylinder, then fill it with fresh brake. fluid.