To perform basic repairs to the brake cylinder to make its disassembly. Shooting brake master cylinder, followed by disassemble capacity, designed for brake fluid. Since the cylinder clear O-ring. Notice the hole in the compensation to hold the piston down the rod and apply the appropriate tool. Use a screwdriver to remove the body of the cylinder lock ring. When you do this to avoid damage the cylinder walls and piston. Pull the primary piston. After him, the turn to extract the secondary piston. Who take out the collection, as well as deepening the spring of the brake master cylinder. For cleaning, in any case do not use abrasives. Retaining rings, rubber parts during repairs be sure to replace with new ones.
To wash the brake master cylinder, use denatured alcohol or clean brake fluid. Other washing liquids used categorically undesirable. When finished washing all the dry compressed air. Cavity brake cylinder, inspect for the presence of mines or corrosion. When found necessary to replace the master cylinder body. Lubricating the cavity with clean brake fluid, with gently push the secondary piston assembly. He must touch the base of the cylinder housing. Do not use iron tools, if necessary, use plastic or wooden rod. Then insert the primary piston. Pushing the pistons in the cylinder to carry out, using a wooden or plastic barbs.
. Jpg "alt =" Chevrolet Aveo – execution of repair brake master cylinder "title =" Chevrolet Aveo – execution of repair brake master cylinder "width =" 150 "height =" 150 "class =" alignleft size-thumbnail wp-image-110 " /> installing a new circlip, avoid damage to the cylinder. The new snap ring, set in a groove located on the cylinder. Then remove the rod. to check the free movement of the piston move it. lubricate the O-ring and the shaft seal in a cavity check. It should be out is facing an open side, to neatly seal on the piston. Then follow the master cylinder fluid reservoir installation. and move on to installing the brake master cylinder. Installing and securing brake master cylinder, you need to make lifting the car and fix it. Then, run leveling braking system. Then lower the car.